DN-8237MB 2-axis Stepper/Servo Motion Control Board for MELSERVO-J2
2-axis pulse-command motion terminal board for Mitsubishi MELSERVO-J2 servo amplifiers, with photo-coupling isolation and wide 20 ~ 26 VDC input for ICP DAS 2-axis motion controllers.
- Photo-coupling isolation on the signal interface to protect the controller
- Supports pulse command type stepper or servo motors
- Power LED and status LEDs for home and limit switches
- FRnet terminal for high-speed serial I/O expansion when the controller supports FRnet
- Onboard power module with wide 20 ~ 26 VDC input, 0.5 A
- Interchangeable terminal connectors for changing axis definitions without rewiring
215,00 EUR per piece
| 1–9 pcs | 215,00 EUR | |
|---|---|---|
| 10–30 pcs | 208,00 EUR | −3 % |
| 31+ pcs | 204,00 EUR | −5 % |
Informații despre produs "DN-8237MB 2-axis Stepper/Servo Motion Control Board for MELSERVO-J2"
The DN-8237MB CR is a motion control daughter board that pairs ICP DAS 2-axis motion controllers with Mitsubishi MELSERVO-J2 servo amplifiers. It is designed to be fitted to compatible controllers such as the I-8092F and PISO-PS200, and it supports pulse command type stepper or servo motors.
Signals are routed through screw terminals grouped by axis. Each group carries the pulse output command lines, encoder feedback lines, special purpose inputs (home, near home and limit switches) and a servo-enable output. Connectors can be swapped to reassign axis definitions without rewiring, and onboard photo-coupling isolation helps protect the controller.
An onboard power module generates the voltages needed by the board from a wide 20 ~ 26 VDC supply, drawing up to 12 W at 24 VDC. Power and status LEDs indicate the state of the board and its limit and home signals. The board is rated for an operating temperature of -20 ~ +75 °C.
Applications
- Two-axis positioning of stepper or servo motors with ICP DAS motion controllers
- Motion control with Mitsubishi MELSERVO-J2 servo amplifiers
- Axis wiring where connector-based axis reassignment is required
| Product type: | Daughter board |
|---|---|
| Interface: | Screw terminal |
| Isolation: | Photo-coupling |
| Power input: | 20 ~ 26 VDC |
| Operating temperature: | -20 ~ +75 °C |
Specifications
| Power | |
|---|---|
| Input Range | 20 ~ 26 VDC, 0.5 A |
| Consumption | 12 W (24 VDC) |
| Mechanical | |
| Dimensions (mm) | 110 mm X 107 mm |
| Environment | |
| Operating Temperature | -20 ~ +75 °C |
| Storage Temperature | -30 ~ +85 °C |
| Humidity | 10 ~ 90% RH, Non-condensing |
Specifications as published by the manufacturer. Subject to change.
Downloads
Login